Call us or use the form at the right to let us know the best way to reach you.
Offices in Ulster County, NY and in San Jose, CA.
Alternative + Renewable Construction LLC
PO Box 453
Cragsmoor, NY 12420
AEP Request Form:
Please fill out and email or send us back the AEP Request Form below:
Thank you for your interest in Advanced Energy Panels.
You're on your way to saving money and energy!
AEP Inquiries: Please scroll down for more info
Advanced Energy Panel (AEP) Information:
• Dark Brown
All four sides of the panel are mounted on trim using twist clip fasteners.
The tops and sides are mounted against trim using twist clip fasteners, and the bottom rests on a sill
Similar to surface mount but recessed against stops, with weather-stripping applied to the backs of all panels only. All four sides of the panel are mounted on trim using angle fasteners.
Similar to surface mount but recessed against stops, with weather- stripping mounted on the backs of all four sides of the panel AND to the bottom edge.
Weather-stripping is applied on the side of the panel instead of the back, and the panel is held in the opening by friction between the weather-stripping and the surface of the opening.
To determine panel dimensions for each panel in your order, first measure your windows and openings, and determine which mounting style is right for you (see above.) Provide final dimensions using the following guidance:
For Surface and Surface-on-Sill mounted panels:
Base the final finished dimensions for the panel frames on the final mounting position you have selected on the trim. Provide the width and height that the finished panels should be.
For recess-mounted panels:
Base the final finished dimensions on the dimensions of the recess within which you will mount the panel. Accuracy is critical: too small and your panels may fail to snug up against the stops you have chosen to mount their backs against; too large and the panel will not fit into the recess at all.
• Recess: Provide the width and height that the finished panels should be.
• Recess-on-Sill: To accommodate the weather-stripping on the bottom edge of this type of panel, you must SUBTRACT 1⁄4” from the height of the recessed opening to determine the final height dimension. (The width is the width of the opening.)
For compression mounted panels:
Measure the opening that you want the panel to fit into. Then subtract 5/8” from the width and 1⁄2” from the height to accommodate the weather-stripping that we will apply to all four edges of the aluminum frame. Provide the final aluminum frame dimensions after subtracting those factors.